SP-109

Tap a section to view your pool information.

Pool DetailsYour pool at a glance

Pool ID: SP-109
Pool volume: 30000 L
Pool type: Fibreglass
Passport created: 28 September 2026
Customer: Test Test
Property address: 1 Test St

EquipmentHealth, settings and warranties

Oasis 20KW Heat Pump

Sunlover Oasis

Good

Recommended settingsNOT OVER 30C!

Installation date01 August 2026

Warranty expiry01 August 2031

View manual

Henden Compact Chlorinator 25g

Henden 25g

Good

Recommended settingsChlorine output at 60-70% in Summer, 40-50% in winter.
8-10hrs per day in Summer
4hrs min per day in Winter

View manual

Theraclear 255 Glass Filter

Theralaux 255

Good

Health notesRunning well, pressure is low as it should be.

Recommended settingsBackwash when pressure reaches 120-150kpa.
Pump will need to be running on the high speed to get a true reading of the pressure.
"Backwash" for 1 minute when required, then "Rinse" until water is clear (Roughly 1 minute)

Installation date01 August 2026

Warranty expiry01 August 2036

View manual

Theralaux TVS Pro 1.25hp

Theralaux TVS Pro 1.25

Good

Health notesPump is working as it should.

Recommended settingsEmpty the pump basket when required, should be checked weekly.
Medium speed is best for everyday running use. Use the pumps high speed when backwashing the filter, cleaning the pool, or running the spa jets.
Medium or low speed is best when running the heater.

Installation date01 August 2026

Warranty expiry01 August 2028

View manual

Water Chemistry CalculatorEnter readings and get a clear treatment plan

Enter water test results from your home test kit or pool shop.

Pool: — Surface: — System: —

Dosage guidance: Estimates use Hy-Clor published product-chart rates for Calcium Increaser (200 g/10,000 L per ~15 ppm) and Stabiliser (500 g/10,000 L per ~50 ppm). Salt uses Passport chlorinator settings; buy whole 20 kg bags but add only the calculated amount. Copper advice depends on the exact controller. Always use calcium hardness (not total hardness) for calcium calculations. Check the exact product label, maximum single dose and application directions; never mix chemicals. Dose each chemical separately in the order shown, allowing the circulation time on its label. Never mix chemicals. For ordinary independent corrections, a single final retest is sufficient; if a step specifically requires an intermediate test, do that before continuing. Do not swim when sanitiser readings are unsafe. Estimates are not water-safety clearance or Hy-Clor approval.

Service HistoryVisits, work completed and photos